POWRIG Optical Glass Lens Protector for Insta360 X6

POWRIG Optical Glass Lens Protector for Insta360 X6

The POWRIG LP-X6 is a pair of optical glass lens guards for the Insta360 X6 — one for each fisheye. Both lenses sit proud of the camera body, exposed every time it goes down on rock, into a jacket pocket or through blowing sand. Built for travel vloggers, motorcyclists, skiers and anyone shooting handheld in the field, these guards take the abuse instead of the lens itself.

Key Advantages

• The camera recognises them automatically — Once locked on, the X6 detects the guards and loads the matching stitching calibration by itself. No menu toggle, no manual profile. This is what separates a purpose-built guard from a generic one, which the camera cannot identify and therefore cannot compensate for.
• AR-coated optical glass — The anti-reflective layer suppresses the flare and ghosting that bare glass introduces when you shoot into the sun, oncoming headlights or a dive torch.
• Pinch-and-twist bayonet lock — Adhesive-free. Squeeze the two textured grips, seat the guard, rotate a quarter turn to lock. It comes off just as cleanly, leaving no residue on the lens rim.
• Sealed against grit — The ring closes against the lens rim so sand and dust cannot migrate into the gap, where trapped grit would otherwise grind the lens coating every time the guard shifts.

Specifications

What's in the Box

• 2 × POWRIG LP-X6 lens protector (front and rear)

How to Install

1. Clean the lens first. Wipe with a microfiber cloth, then blow off any remaining dust. Grit sealed underneath a guard is the one thing that will show up in your footage.
2. Pinch and seat. Squeeze the two textured grips on the ring, line the guard up over the lens and press it on evenly rather than at an angle.
3. Twist a quarter turn. Rotate until the blue index mark sits horizontal. That is the locked position — the guard will not back off on its own.
4. Check the screen. The X6 displays a lens-guard icon once it has identified the pair. No icon means the guard is not fully seated: unlock, reseat and twist again.
5. Repeat on the second lens. Run both guards together. Fitting only one leaves the two lenses optically mismatched.

Compatibility

Rigging the X6 above water? The POWRIG AC-X6 aluminum cage works alongside these guards and adds a cold shoe. Going deep instead, the 60m diving case for the Insta360 X6 replaces them with a sealed dome. Full range in action cam accessories.